Hourly rate | $65 |
Minimum charge per gun | $35 |
“High 5” Accurizing: Recrowning, free float barrel, pillar / glass bedding, adjust or replace trigger (trigger cost extra), remounting of scope with lapping of rings. | $375 |
Function test fire only | $30 |
Uncertified written appraisals, cost estimates | $75 |
Tactical bolt knob installation (Remington, Winchester, Savage, Weatherby, Howa). Stainless bolts $75. | $70 |
Bolt Stop Button | $125 |
Detailed clean, oil, check, make suggestions | $75 |
Assemble & reassemble firearm (complex firearms extra) | hourly |
Bead Blast Barrel | $35 |
Bore sight | $20 |
Install receiver sights (gun drilled & tapped) | $35 |
Scope mounting & truing (gun drilled & tapped) | $75 |
Install recoil pad (materials extra) | $115 |
Install adjustable butt plate (materials extra) | $135 |
Install sling swivels – qty. 2 (materials extra) | $65 |
Check head space | $35 |
Check firing pin protrusion | $35 |
Drill & tap barrel or receiver (per hole) | $30 |
Cut dovetail in barrel | $135 |
Make chamber cast | $85 |
Remove fired case from chamber | hourly |
Remove obstruction from bore | hourly |
Remove fouling (materials extra) | hourly |
Lap barrel | $65 |
Install liner in barrel (liner, bluing extra. .22 RF only) | $125 |
Cut & crown barrel | $95 |
Chamber & fit barrel to action (barrel, action, polishing, bluing extra) | $275 |
Install pre-threaded & chambered barrel (polishing, bluing extra) | $165 |
Make & install spring (materials extra) | hourly |
Install safety | $125 |
Install or adjust trigger (Shilen, Timney, Dayton-Traister, Moyer) | $65 |
Install or adjust trigger (single set) | $125 |
Install muzzle brake | $145 |
Install muzzle brake (with receiver removal) | $165 |
Blueprint receiver | $250 |
Install barrel band | hourly |
Spray finish stock (paint or Cerakote) | $95 |
Glass bedding barrel and action, hunting rifle | $200 |
Glass bedding barrel and action, match or military rifle | $250 |
Pillar bed (in addition to glass) | $125 |
Inlet and finish semi-finished stock (no checkering or attachments) | $350 |
Fit, bed and finish fiberglass stock | $200 |
Install adjustable comb hardware | $165 |
Install Sako/M16-style extractor | $130 |